2

Both wallet and CLI are showing the incorrect balance after many full blockchain rescans, trying with the CLI, same result, rescan from genesis block and arbitrary block numbers, same result.

Full balance was there before the fork, and after the fork, a few txns made well before the fork (1 week+) have been rejected which makes up a significant portion of my balance. I know the funds are still there but the wallet cannot "see" them.

x64 ubuntu 18.04, V0.13.0.3, monerod running with GUI on top

gui terminal export ubuntu x64 18.04

Improve this question
4
  • Any luck w/ resolving this issue?
    – dEBRUYNE
    Commented Oct 26, 2018 at 7:22
  • No, not yet, Downloaded 13.0.4 and re synced the blockchain from scratch, full balance is not showing
    – Grosso_
    Commented Oct 30, 2018 at 15:36
  • Did you also run rescan_bc in the wallet thereafter?
    – dEBRUYNE
    Commented Oct 30, 2018 at 20:04
  • Yes, did a rescan_bc in the CLI wallet and a full wallet refresh from genesis in the GUI. CLI does not show the errors like the GUI, but getting the same messages as above, and same balance across both wallets. There are about 5 or so txn pre fork not showing up, cause of above errors, and one transaction post fork which has shown up with no issues
    – Grosso_
    Commented Oct 31, 2018 at 15:07

1 Answer 1

Reset to default
1

Your transaction has an ADDITIONAL_PUBKEYS tag in the tx_extra field. This means it was a transaction with at least two destinations, at least one of which was a subaddress.

These warnings mean that your wallet does not know how to interpret this ADDITIONAL_PUBKEYS tag. Therefore your wallet must be an older wallet version that does not support subaddresses. Please check that you're using the latest GUI wallet.

Improve this answer
1
  • Thanks for your insight, I am using 13.0.2 for monerod and 13.0.3 for the GUI, I am re-syncing the blockchain from genesis to see if that helps
    – Grosso_
    Commented Oct 23, 2018 at 20:03

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.