0

Running monero-wallet-cli on macOS gives me this error:

The wallet's refresh-from-block-height setting is higher than the daemon's height: this may mean your wallet will skip over transactions

The wallet CLI then quits.

Poking around I have found out that the wallet block height is 2365949, and monerod lists height as 1273180/2365980.

I have tried to do a rescan_bc on the wallet from a lower height, but this has no effect.

So I think maybe I should change the height on monerod.

Looking at the monerod command line options I can't see a way to change it - or is there some other way to solve this problem?

3
  • 1
    May not be a problem. Both are catching up. monerod to blockchain and the wallet to monerod.
    – Dave
    May 21 at 21:54
  • 1
    "monerod lists height as 1273180/2365980." <- your daemon is not fully synchronized.
    – jtgrassie
    May 22 at 0:57
  • @Dave and @jtgrassie - You are right, the problem went away once monerod got synchronized. There's no mention of this in the docs or any of the guides I have found, so it's easy to miss this point. Thank you for your comments. May 22 at 12:38
1

...monerod lists height as 1273180/2365980

Your daemon is not fully synchronized.

When fully sync'ed, you won't get the wallet message mentioned.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.